AUTOMATIC STEP DOWN - STEP UP MODULE 2A IN 4 -35V OUT 1.25 -25V

Κωδικός Προϊόντος: 05.13.0038

AUTOMATIC STEP DOWN - STEP UP MODULE ΜΕ ΡΥΘΜΙΣΤΙΚΑ ΤΑΣΗΣ-ΕΝΤΑΣΗΣ
Specification:
Input Voltage: 4-35V
Output voltage: Continuously adjustable(1.25-25V unload adjust)
Output current: 3A Max(If more than 15W, please install the heat sink)
CC range: 0-2A (adjustable)
Revolving light current: CC value * (1%-100%), default is 0.1 times
Minimum voltage difference: 2V
Output power: natural cooling 15W
Conversion efficiency: 80% (the higher the output voltage, the higher the efficiency)
Operating Temperature: Industrial (-40 ° to +85 °) (ambient temperature more than 40°, lower power use, or add heat sink)
Full load temperature rise: 45 °
Indicator: CC indicator is Red, charging indicator is Red, charging completed the indicator is Blue.
Output short circuit protection: Yes, constant current.
Connect method: Can solder on the PCB with wire directly
Input: IN+ input Positive is, IN- input negative
Output: OUT+ output is positive, OUT- output negative
Module Size: 50 x 37 x 13mm

Διαβάστε Περισσότερα Διαβάστε Λιγότερα

AUTOMATIC STEP DOWN - STEP UP MODULE 2A IN 4 -35V OUT 1.25 -25V is available for purchase in increments of 1

Διαθεσιμότητα:Άμεσα Διαθέσιμο / 1-3 Εργάσιμες

Τιμή eshop (Με ΦΠΑ) 10,00€

Περιγραφή Προϊόντος

Λεπτομέρειες

Used as a general step-up and step-down module with overcurrent protection capability

Instructions:

(1) Adjust the CV constant voltage potentiometer so that the output voltage reaches the value you want.

(2) with the multimeter 10A current measurement output short-circuit current (directly to the two test leads can be connected to the output), while adjusting the CC constant current potentiometer so that the output current to achieve a predetermined over-current protection value. (Such as multimeter shows the current value is 2A, then you use the module when the maximum current can only be 2A, the current to 2A when the red constant voltage constant current indicator light, otherwise the indicator light off)

Note: When used in this state, because the output has 0.05 ohm current sampling resistor, connected to the load will be 0 ~ 0.3V voltage drop, this is a normal phenomenon! This voltage drop is not pulled down by your load, but is reduced to the sampling resistor.

Κατηγορίες

AUTOMATIC STEP DOWN - STEP UP MODULE 2A IN 4 -35V OUT 1.25 -25V

Λεπτομέρειες

Χρήσιμα

Ωράριο Καταστήματος

Τραπεζικοί Λογαριασμοί